Page 1 of 1

Thermostat not showing 'Cooling'

PostPosted: Sat Aug 06, 2011 9:24 am
by andyf0
Wes, I just happened to check the thermostat and noticed it wasn't showing "Cooling" when the Cool Control was ON. Am I imagining that it used to show that?

Re: Thermostat not showing 'Cooling'

PostPosted: Sat Aug 06, 2011 3:41 pm
by AdminWes
MobiLinc does show this if the ISY can see it. I've seen cases where if your ISY is rebooted it won't get the COOLING/HEATING status of the Thermostat until the thermostat cycles from COOLING to Off and then back to COOLING.

If you think MobiLinc should be displaying COOLING check the ISY and see if the Admin console shows COOLING for your Thermostat.

Wes

Re: Thermostat not showing 'Cooling'

PostPosted: Sun Aug 07, 2011 3:35 pm
by andyf0
The ISY shows Cool Control 'On' and in the Thermostat node Heat/Cool state shows 'Cool On'.

This worked prior to the current release, I'm merely suggesting it may be broken in the current release.

Re: Thermostat not showing 'Cooling'

PostPosted: Sun Aug 07, 2011 5:52 pm
by AdminWes
Hi Andy,

If the Cool Control is reading ON from the Admin Console, then the ISY should be sending this info to MobiLinc. Try doing a force close and reopen MobiLinc to force MobiLinc into getting the current status for everything. Does COOLING now appear on the Thermostat page in MobiLinc?

One more thing to check, does the Venstar have the Green front LED lit indicating it is actively trying to cool the house?

Wes

Re: Thermostat not showing 'Cooling'

PostPosted: Mon Aug 08, 2011 6:30 am
by andyf0
Hi Wes,

Closing it down and re-opening it did the trick, I'll have to remember that in the future. Sorry about suggesting a bug. I wonder how it got in that state? Could it be related to the fact I replaced the thermostat adapter with an updated one? It must have done, MobiLincs cached data probably still had the old device information which makes me wonder how the other functions worked. Oh Well! All is good now.

Re: Thermostat not showing 'Cooling'

PostPosted: Tue Aug 09, 2011 7:57 pm
by AdminWes
Hi Andy,

Great! Glad that did the trick. I'm assuming it had to do with the old adapter being swapped out.

Wes

Re: Thermostat not showing 'Cooling'

PostPosted: Thu Dec 22, 2011 4:30 pm
by andyf0
Wes, I got into this state again and I think I know how I got there. If you manually adjust a set point using the up or down button on the thermostat screen it gets into the state where it doesn't display HEATING or COOLING. Normal thermostat scenes (setting ON) don't appear to create this problem. The only way I could get it back into normal operation was to Download All.

Re: Thermostat not showing 'Cooling'

PostPosted: Fri Dec 23, 2011 3:11 pm
by AdminWes
Hi Andy,

I'm seeing an issue where my ISY isn't showing Heat when the thermostat is Heating. So I'm not sure what's going on with the latest beta firmware from UDI. I'll have to investigate this further on my end.

When you are in this condition what does the Admin Console say? Both the Admin Console and MobiLinc should be in agreement. Right now my Admin Console says nothing about Heating or Cooling and MobiLinc says the same thing. Not Heating or Cooling when the thermostat is Heating currently.

Wes