Hello again Wes,
I am running into my next issue:
I have Geofencing on set up a program, but it dies not run, I get the notifications on the iPhone that I am entering the zone, and exiting, but the program does not appear to run.
On the iPhone The State Vars is: Value: 1 when I am in the house and Status: Initial: 2
Under the "Programs" tab, Enabled: Yes Status: False
Integer Vars: No Variables Detected.
When I click on the program, and Run If Command, Run Them Command, it turns the lights on as requested, and Run Else Command, it turns them off. I clicked the "Enable Program" and "Enable at startup".
So when running it manually in my iPhone, it appears to work, but not on its own, when I am entering or leaving the zone. What am I missing?
this is a copy of the program from the ISY-99i:
If
$iPhone_Home is 1
and Time is Sunset
Then
Set '00_Garage' On
Set '01_Solarium' On
Set '01_Kitchen' On
Wait 5 minutes
Set '00_Garage' Off
Set '01_Solarium' Off
Else
Set '00_Garage' Off
Set '01_Solarium' Off
Set '01_Kitchen' Off
Meaning to turn the garage, solarium and kitchen light on when I come home after sunset and to turn the garage and solarium off after 5 minutes.
Else to turn them off when I leave the zone
Thanks in advance,
Pierre